My Cart
Your Cart 0

    Your cart is empty.

  • Total (Amount) ₹0.00
Previous year question hub

Lines - Geometry - General Aptitude (GA) Previous Year Questions

Practice Lines - Geometry - General Aptitude (GA) previous year questions organised from real papers, with year-wise coverage and clear topic navigation.

2Papers
2Years
4Questions
1Topics

Lines question pattern

Every graph below is calculated only from this selection.

Questions by year

Year-wise coverage for Lines. Each bar uses a separate theme-derived color.

Difficulty distribution

How the classified questions are distributed by difficulty.

Medium 3 75%
Easy 1 25%

Question type distribution

MCQ, numerical, multiple-select and other formats found in these papers.

MCQ 4 100%

Subject weightage

Top subjects by unique question coverage.

General Aptitude (GA)
4 Qs

Most asked topics

Top topics across the included previous year papers.

Geometry
4 Qs

Subtopic coverage

Top subtopics inside this exact selection.

Lines
4 Qs

Paper coverage

Question coverage for the most populated papers. Every active PYP paper remains listed below.

Mechanical Engineering (ME) 2016 [Session 3]
1 Qs
Mechanical Engineering (ME) 2015 [Session 3]
3 Qs

Included previous year papers

Newest papers appear first. Sort by year, question coverage or name.

PaperYear / sessionQuestions in this viewOpen
Mechanical Engineering (ME) 2016 [Session 3]20161View paper
Mechanical Engineering (ME) 2015 [Session 3]20153View paper

All Lines previous year questions

Practice every matching question in batches of 20, with every available option.

1
2015 · General Aptitude (GA) · Geometry · Lines
Mechanical Engineering (ME) 2015 [Session 3]
In a machining operation, if the generatrix and directrix both are straight lines, the surface obtained is
Open complete paper
2
2015 · General Aptitude (GA) · Geometry · Lines
Mechanical Engineering (ME) 2015 [Session 3]
A drill is positioned at point P and it has to proceed to point Q. The coordinates of point Q in the incremental system of defining position of a point in CNC part program will be

Question diagram

Open complete paper
3
2015 · General Aptitude (GA) · Geometry · Lines
Mechanical Engineering (ME) 2015 [Session 3]
A shaft of length 90 mm has a tapered portion of length 55 mm. The diameter of the taper is 80 mm at one end and 65 mm at the other. If the taper is made by tailstock set over method, the taper angle and the set over respectively are
Open complete paper
4
2016 · General Aptitude (GA) · Geometry · Lines
Mechanical Engineering (ME) 2016 [Session 3]
M and N start from the same location. M travels 10 km East and then 10 km North-East. N travels 5 km South and then 4 km South-East. What is the shortest distance (in km) between M and N at the end of their travel?
Open complete paper