- Total number of questions: 65
- 30 questions carry one mark each
- 35 questions carry two marks each
- Negative marking: 1/3 of the marks allotted to the question
- Use of calculator is allowed
- This is a proctored examination
- All other browser applications will be automatically closed
- After three warnings, the examination window will close automatically
Exam Details
Production & Industrial Engineering (PI) 2013 [Session 2]
Review the key details, then start the test when you are ready. You can also open the full package to see related papers.
Questions
65
Duration
180 mins
Package
Production & Industrial Engineering (PI) - Previous Year Papers
Paper pattern & analysis
Filter this paper by subject, topic or subtopic. Every graph updates from the selected questions.
Topic distribution
Subtopic distribution
Difficulty distribution
65questions
Easy
65
100%
Question type distribution
65questions
Multiple Choices
65
100%
Instructions
Production & Industrial Engineering (PI) 2013 [Session 2] – Instructions
Syllabus
Full Syllabus
Sample questions from this paper
Questions are selected across the paper subjects wherever the paper contains that variety.
2013 · Unclassified
Production & Industrial Engineering (PI) 2013 [Session 2]
Q.1 – Q.25 carry one mark each.
The type of control chart used to monitor the amount of dispersion in a sample is
A
B
C
D
2013 · Unclassified
Production & Industrial Engineering (PI) 2013 [Session 2]
Which one of the following is modeled based on adaptation capabilities of biological systems?
2013 · Unclassified
Production & Industrial Engineering (PI) 2013 [Session 2]
A company manufactures 1000 toys every day. On an average, 10% of the toys are defective and 40% of the defective toys can be reworked into defect-free ones. The average number of defect-free toys manufactured daily is
2013 · Unclassified
Production & Industrial Engineering (PI) 2013 [Session 2]
In simple exponential smoothing forecasting, to give higher weightage to recent demand information, the smoothing constant must be close to
2013 · Unclassified
Production & Industrial Engineering (PI) 2013 [Session 2]
In the 3-2-1 principle of fixture design, 3 refers to the number of
2013 · Unclassified
Production & Industrial Engineering (PI) 2013 [Session 2]
A steel bar 200 mm in diameter is turned at a feed of 0.25 mm/rev with a depth of cut of 4 mm. The rotational speed of the workpiece is 160 rpm. The material removal rate in mm3/s is