My Cart
Your Cart 0

    Your cart is empty.

  • Total (Amount) ₹0.00
Exam Details

Instrumentation Engineering (IN) 2013 [Session 3]

Review the key details, then start the test when you are ready. You can also open the full package to see related papers.

Questions 65
Duration 180 mins
Package Instrumentation Engineering (IN) - Previous Year Papers

Paper pattern & analysis

Filter this paper by subject, topic or subtopic. Every graph updates from the selected questions.

Explore previous papers
Showing all 65 questions in this paper.

Subject distribution

No subject classification is available.

Topic distribution

No topic classification is available.

Subtopic distribution

No subtopic classification is available.

Difficulty distribution

Easy 65 100%

Question type distribution

Multiple Choices 65 100%

Instructions

Instrumentation Engineering (IN) 2013 [Session 3] – Instructions
  • Total number of questions: 65
  • 30 questions carry one mark each
  • 35 questions carry two marks each
  • Negative marking: 1/3 of the marks allotted to the question
  • Use of calculator is allowed
  • This is a proctored examination
  • All other browser applications will be automatically closed
  • After three warnings, the examination window will close automatically

Syllabus

Full Syllabus

Sample questions from this paper

Questions are selected across the paper subjects wherever the paper contains that variety.

1
2013 · Unclassified
Instrumentation Engineering (IN) 2013 [Session 3]
Q.1 – Q.25 carry one mark each.

The transfer function V2(s)/V1(s) of the circuit shown below is

A
0.5s + 1/s + 1
B
3s + 6/s + 2
C
s + 2/s + 1
D
s + 1/s + 2
2
2013 · Unclassified
Instrumentation Engineering (IN) 2013 [Session 3]

Assuming zero initial condition, the response y(t) of the system given below to a unit step input u(t) is

A
u(t)
B
tu(t)
C
t²/2 u(t)
D
eᵗ u(t)
3
2013 · Unclassified
Instrumentation Engineering (IN) 2013 [Session 3]

The operational amplifier shown in the circuit below has a slew rate of 0.8 Volts/μs. The input signal is 0.25 sin(ωt). The maximum frequency of input in kHz for which there is no distortion in the output is

A
23.84
B
25.0
C
50.0
D
46.60
4
2013 · Unclassified
Instrumentation Engineering (IN) 2013 [Session 3]

Which one of the following statements is NOT TRUE for a continuous time causal and stable LTI system?

A
All the poles of the system must lie on the left side of the jω axis.
B
Zeros of the system can lie anywhere in the s-plane.
C
All the poles must lie within |s| = 1.
D
All the roots of the characteristic equation must be located on the left side of the jω axis.
5
2013 · Unclassified
Instrumentation Engineering (IN) 2013 [Session 3]

A source vs(t) = V cos100πt has an internal impedance of 4 + j3 Ω. If a purely resistive load connected to this source has to extract the maximum power out of the source, its value in Ω should be

A
3
B
4
C
5
D
7
6
2013 · Unclassified
Instrumentation Engineering (IN) 2013 [Session 3]

In the transistor circuit as shown below, the value of resistance Re in kΩ is approximately.

A
1.0
B
1.5
C
2.0
D
2.5