My Cart
Your Cart 0

    Your cart is empty.

  • Total (Amount) ₹0.00
Exam Details

Electrical Engineering (EE) 2013 [Session 2]

Review the key details, then start the test when you are ready. You can also open the full package to see related papers.

Questions 65
Duration 180 mins
Package Electrical Engineering (EE) - Previous Year Papers

Paper pattern & analysis

Filter this paper by subject, topic or subtopic. Every graph updates from the selected questions.

Explore previous papers
Showing all 65 questions in this paper.

Subject distribution

No subject classification is available.

Topic distribution

No topic classification is available.

Subtopic distribution

No subtopic classification is available.

Difficulty distribution

Easy 65 100%

Question type distribution

Multiple Choices 65 100%

Instructions

Electrical Engineering (EE) 2013 [Session 2] – Instructions
  • Total number of questions: 65
  • 30 questions carry one mark each
  • 35 questions carry two marks each
  • Negative marking: 1/3 of the marks allotted to the question
  • Use of calculator is allowed
  • This is a proctored examination
  • All other browser applications will be automatically closed
  • After three warnings, the examination window will close automatically

Syllabus

Full Syllabus

Sample questions from this paper

Questions are selected across the paper subjects wherever the paper contains that variety.

1
2013 · Unclassified
Electrical Engineering (EE) 2013 [Session 2]
Q.1 – Q.25 carry one mark each.

The input impedance of the permanent magnet moving coil (PMMC) voltmeter is infinite. Assuming that the diode shown in the figure below is ideal, the reading of the voltmeter in Volts is

Question diagram

A
4.46
B
3.15
C
2.23
D
0
2
2013 · Unclassified
Electrical Engineering (EE) 2013 [Session 2]

In the feedback network shown below, if the feedback factor k is increased, then the

Question diagram

A
input impedance increases and output impedance decreases.
B
input impedance increases and output impedance also increases.
C
input impedance decreases and output impedance also decreases.
D
input impedance decreases and output impedance increases.
3
2013 · Unclassified
Electrical Engineering (EE) 2013 [Session 2]

The Bode plot of a transfer function G(s) is shown in the figure below.

Question diagram

The gain (20 log|G(jω)|) is 32 dB and -8 dB at 1 rad/s and 10 rad/s respectively. The phase is negative for all ω. Then G(s) is
A
39.8/s
B
39.8/s²
C
32/5
D
32/s²
4
2013 · Unclassified
Electrical Engineering (EE) 2013 [Session 2]

A bulb in a staircase has two switches, one switch being at the ground floor and the other one at the first floor. The bulb can be turned ON and also can be turned OFF by any one of the switches irrespective of the state of the other switch. The logic of switching of the bulb resembles

A
an AND gate
B
an OR gate
C
an XOR gate
D
a NAND gate
5
2013 · Unclassified
Electrical Engineering (EE) 2013 [Session 2]

For a periodic signal v(t) = 30 sin 100t + 10 cos 300t + 6 sin (500t + π/4), the fundamental frequency in rad/s is

A
100
B
300
C
500
D
1500
6
2013 · Unclassified
Electrical Engineering (EE) 2013 [Session 2]

A band-limited signal with a maximum frequency of 5 kHz is to be sampled. According to the sampling theorem, the sampling frequency in kHz which is not valid is

A
5
B
12
C
15
D
20