My Cart
Your Cart 0

    Your cart is empty.

  • Total (Amount) ₹0.00
Previous year question hub

Cones - Geometry - General Aptitude (GA) Previous Year Questions

Practice Cones - Geometry - General Aptitude (GA) previous year questions organised from real papers, with year-wise coverage and clear topic navigation.

3Papers
3Years
3Questions
1Topics

Cones question pattern

Every graph below is calculated only from this selection.

Questions by year

Year-wise coverage for Cones. Each bar uses a separate theme-derived color.

Difficulty distribution

How the classified questions are distributed by difficulty.

Medium 2 66.7%
Easy 1 33.3%

Question type distribution

MCQ, numerical, multiple-select and other formats found in these papers.

MCQ 2 66.7%
Numerical Answer Type (NAT) 1 33.3%

Subject weightage

Top subjects by unique question coverage.

General Aptitude (GA)
3 Qs

Most asked topics

Top topics across the included previous year papers.

Geometry
3 Qs

Subtopic coverage

Top subtopics inside this exact selection.

Cones
3 Qs

Paper coverage

Question coverage for the most populated papers. Every active PYP paper remains listed below.

Production & Industrial Engineering (PI) 2024
1 Qs
Production & Industrial Engineering (PI) 2021
1 Qs
Production & Industrial Engineering (PI) 2015
1 Qs

Included previous year papers

Newest papers appear first. Sort by year, question coverage or name.

PaperYear / sessionQuestions in this viewOpen
Production & Industrial Engineering (PI) 202420241View paper
Production & Industrial Engineering (PI) 202120211View paper
Production & Industrial Engineering (PI) 201520151View paper

All Cones previous year questions

Practice every matching question in batches of 20, with every available option.

1
2015 · General Aptitude (GA) · Geometry · Cones
Production & Industrial Engineering (PI) 2015
During the measurement of internal taper of a part using standard balls of diameter 15 mm and 20 mm, the large ball is found to protrude by 5 mm (h1) and the top of small ball is found to be 35 mm (h2) below the top face of the gauge. The taper angle, in degree, is __________

Question diagram

Open complete paper
2
2021 · General Aptitude (GA) · Geometry · Cones
Production & Industrial Engineering (PI) 2021
Consider a square sheet of side 1 unit. In the first step, it is cut along the main diagonal to get two triangles. In the next step, one of the cut triangles is revolved about its short edge to form a solid cone. The volume of the resulting cone, in cubic units, is ______
Open complete paper
3
2024 · General Aptitude (GA) · Geometry · Cones
Production & Industrial Engineering (PI) 2024
Visualize two identical right circular cones such that one is inverted over the other and they share a common circular base. If a cutting plane passes through the vertices of the assembled cones, what shape does the outer boundary of the resulting cross-section make?
Open complete paper