My Cart
Your Cart 0

    Your cart is empty.

  • Total (Amount) ₹0.00
Previous year question hub

Circles - Geometry - General Aptitude (GA) Previous Year Questions

Practice Circles - Geometry - General Aptitude (GA) previous year questions organised from real papers, with year-wise coverage and clear topic navigation.

3Papers
3Years
3Questions
1Topics

Circles question pattern

Every graph below is calculated only from this selection.

Questions by year

Year-wise coverage for Circles. Each bar uses a separate theme-derived color.

Difficulty distribution

How the classified questions are distributed by difficulty.

Medium 2 66.7%
Easy 1 33.3%

Question type distribution

MCQ, numerical, multiple-select and other formats found in these papers.

MCQ 2 66.7%
Numerical Answer Type (NAT) 1 33.3%

Subject weightage

Top subjects by unique question coverage.

General Aptitude (GA)
3 Qs

Most asked topics

Top topics across the included previous year papers.

Geometry
3 Qs

Subtopic coverage

Top subtopics inside this exact selection.

Circles
3 Qs

Paper coverage

Question coverage for the most populated papers. Every active PYP paper remains listed below.

Production and Industrial Engineering (PI) 2026
1 Qs
Production & Industrial Engineering (PI) 2018
1 Qs
Production & Industrial Engineering (PI) 2015
1 Qs

Included previous year papers

Newest papers appear first. Sort by year, question coverage or name.

PaperYear / sessionQuestions in this viewOpen
Production and Industrial Engineering (PI) 202620261View paper
Production & Industrial Engineering (PI) 201820181View paper
Production & Industrial Engineering (PI) 201520151View paper

All Circles previous year questions

Practice every matching question in batches of 20, with every available option.

1
2015 · General Aptitude (GA) · Geometry · Circles
Production & Industrial Engineering (PI) 2015
In a slab milling operation, a cutter of 75 mm diameter with sufficient width is used to remove 5 mm thick material from a 200 mm long part in a single pass. The minimum length of travel, in mm, for the cutter to engage and completely cut the part surface is ____________________.
Open complete paper
2
2018 · General Aptitude (GA) · Geometry · Circles
Production & Industrial Engineering (PI) 2018

The perimeters of a circle, a square and an equilateral triangle are equal. Which one of the following statements is true?

Open complete paper
3
2026 · General Aptitude (GA) · Geometry · Circles
Production and Industrial Engineering (PI) 2026
In the given figure, \(\overline{PQ}\) is the diameter of a circle with center \(O\). Two points \(R\) and \(S\) are chosen on the circle such that \(\angle ROS = 80^\circ\). When \(PR\) and \(QS\) are extended, they meet at \(T\). The value of \(\angle RTS\) is ________

Question source image

Open complete paper