My Cart
Your Cart 0

    Your cart is empty.

  • Total (Amount) ₹0.00
Previous year question hub

Lines - Geometry - General Aptitude (GA) Previous Year Questions

Practice Lines - Geometry - General Aptitude (GA) previous year questions organised from real papers, with year-wise coverage and clear topic navigation.

4Papers
4Years
6Questions
1Topics

Lines question pattern

Every graph below is calculated only from this selection.

Questions by year

Year-wise coverage for Lines. Each bar uses a separate theme-derived color.

Difficulty distribution

How the classified questions are distributed by difficulty.

Medium 4 66.7%
Easy 2 33.3%

Question type distribution

MCQ, numerical, multiple-select and other formats found in these papers.

MCQ 5 83.3%
Numerical Answer Type (NAT) 1 16.7%

Subject weightage

Top subjects by unique question coverage.

General Aptitude (GA)
6 Qs

Most asked topics

Top topics across the included previous year papers.

Geometry
6 Qs

Subtopic coverage

Top subtopics inside this exact selection.

Lines
6 Qs

Paper coverage

Question coverage for the most populated papers. Every active PYP paper remains listed below.

Mining Engineering (MN) 2021
1 Qs
Mining Engineering (MN) 2018
1 Qs
Mining Engineering (MN) 2015
3 Qs
Mining Engineering (MN) 2014
1 Qs

Included previous year papers

Newest papers appear first. Sort by year, question coverage or name.

PaperYear / sessionQuestions in this viewOpen
Mining Engineering (MN) 202120211View paper
Mining Engineering (MN) 201820181View paper
Mining Engineering (MN) 201520153View paper
Mining Engineering (MN) 201420141View paper

All Lines previous year questions

Practice every matching question in batches of 20, with every available option.

1
2014 · General Aptitude (GA) · Geometry · Lines
Mining Engineering (MN) 2014

X is 1 km northeast of Y. Y is 1 km southeast of Z. W is 1 km west of Z. P is 1 km south of W. Q is 1 km east of P. What is the distance between X and Q in km?

Open complete paper
2
2015 · General Aptitude (GA) · Geometry · Lines
Mining Engineering (MN) 2015

The angle in degrees at which a ridge line intersects contours is

Open complete paper
3
2015 · General Aptitude (GA) · Geometry · Lines
Mining Engineering (MN) 2015
A force of 50 N is applied to a wrench as shown in the figure. The magnitude of the moment in N-mm of this force about the point P is __________

Question diagram

Open complete paper
4
2015 · General Aptitude (GA) · Geometry · Lines
Mining Engineering (MN) 2015
Biaxial stresses at a point inside a pillar are shown in the figure.
The magnitude of the maximum shear stress in MPa and its direction with the x-axis in degrees at the same point respectively are

Question diagram

Open complete paper
5
2018 · General Aptitude (GA) · Geometry · Lines
Mining Engineering (MN) 2018
In the figure below, \( \angle DEC + \angle BFC \) is equal to ________.

Question diagram

Open complete paper
6
2021 · General Aptitude (GA) · Geometry · Lines
Mining Engineering (MN) 2021
On a planar field, you travelled 3 units East from a point O. Next you travelled 4 units South to arrive at point P. Then you travelled from P in the North-East direction such that you arrive at a point that is 6 units East of point O. Next, you travelled in the North-West direction, so that you arrive at point Q that is 8 units North of point P.
The distance of point Q to point O, in the same units, should be_____
Open complete paper