Data Interpretation - General Aptitude - General Aptitude (GA) Previous Year Questions

1

2012 · General Aptitude (GA) · General Aptitude · Data Interpretation

Mechanical Engineering (ME) 2012

Which one of the following is NOT a decision taken during the aggregate production planning stage?

A

Scheduling of machines

B

Amount of labour to be committed

C

Rate at which production should happen

D

Inventory to be carried forward

Open complete paper

2

2015 · General Aptitude (GA) · General Aptitude · Data Interpretation

Mechanical Engineering (ME) 2015 [Session 1]

Consider a slider crank mechanism with nonzero masses and inertia. A constant torque τ is applied on the crank as shown in the figure. Which of the following plots best resembles variation of crank angle, θ versus time

A

A graph of θ vs time showing a straight line with positive slope starting from origin.

B

A graph of θ vs time showing a curve that starts at origin, rises, falls, and rises again (oscillatory).

C

A graph of θ vs time showing a curve that starts at origin and increases at an increasing rate (concave up).

D

A graph of θ vs time showing a curve that starts at origin and increases with some oscillations (wavy).

Open complete paper

3

2015 · General Aptitude (GA) · General Aptitude · Data Interpretation

Mechanical Engineering (ME) 2015 [Session 1]

A horizontal plate has been joined to a vertical post using four rivets arranged as shown in the figure. The magnitude of the load on the worst loaded rivet (in N) is ______

Check answer

Open complete paper

4

2015 · General Aptitude (GA) · General Aptitude · Data Interpretation

Mechanical Engineering (ME) 2015 [Session 3]

In the notation (a/b/c) : (d/e/f) for summarizing the characteristics of queueing situation, the letters ‘b’ and ‘d’ stand respectively for

A

service time distribution and queue discipline

B

number of servers and size of calling source

C

number of servers and queue discipline

D

service time distribution and maximum number allowed in system

Open complete paper

5

2015 · General Aptitude (GA) · General Aptitude · Data Interpretation

Mechanical Engineering (ME) 2015 [Session 3]

A solid sphere 1 of radius r is placed inside a hollow, closed hemispherical surface 2 of radius 4r. The shape factor F_2-1 is

A

1/12

B

1/2

C

2

D

12

Open complete paper

6

2015 · General Aptitude (GA) · General Aptitude · Data Interpretation

Mechanical Engineering (ME) 2015 [Session 3]

For the overhanging beam shown in figure, the magnitude of maximum bending moment (in kN-m) is ____

Check answer

Open complete paper