Exam Details
2016 Mechanical Engineering Paper - II_2
Review the key details, then start the test when you are ready. You can also open the full package to see related papers.
Questions
120
Duration
180 mins
Package
Indian Economic Service and Indian Statistical Service Examination - Previous Year Papers
Paper pattern & analysis
Filter this paper by subject, topic or subtopic. Every graph updates from the selected questions.
Topic distribution
Subtopic distribution
Difficulty distribution
120questions
Easy
40
33.3%
Medium
40
33.3%
Hard
40
33.3%
Question type distribution
120questions
Multiple Choices
120
100%
Syllabus
Full Syllabus
Sample questions from this paper
Questions are selected across the paper subjects wherever the paper contains that variety.
2016 · Unclassified
2016 Mechanical Engineering Paper - II_2
Consider the following motions :
1. Piston reciprocating inside an engine cylinder
2. Motion of a shaft between foot-step bearings
Which of the above can rightly be considered as successfully constrained motion?
2016 · Unclassified
2016 Mechanical Engineering Paper - II_2
A rotor weighing 2 kN is supported on bearings A and B which are 1 m apart. The centre of mass of the rotor is at a distance 0·4 m from bearing A. It is observed that there is an unbalanced couple of magnitude 300 N-m which leaves the shaft balanced statically. The dynamic reactions at the supports will be
2016 · Unclassified
2016 Mechanical Engineering Paper - II_2
A cam is a mechanical member used to impart a desired motion to a follower by direct contact. Which one of the under-listed follower motion types will produce the least jerk to the system?
2016 · Unclassified
2016 Mechanical Engineering Paper - II_2
In a circular arc cam with a roller follower, acceleration of the follower depends on
1. cam speed and location of centre of circular arc
2. roller diameter and radius of circular arc
Which of the above is/are correct?
2016 · Unclassified
2016 Mechanical Engineering Paper - II_2
A manufacturing company is selling a product for ₹ 15 per unit with variable cost of ₹ 10 per unit. The fixed cost of the asset is ₹ 50,000. How many units should be produced to breakeven?
2016 · Unclassified
2016 Mechanical Engineering Paper - II_2
In a crank and slotted lever quick return motion mechanism, the distance between the fixed centres is 200 mm. The lengths of the driving crank and the slotted bar are 100 mm and 500 mm, respectively. The length of the cutting stroke is